How to Install Windows Vista from Bootable USB Flash Memory Drive

You can even install Windows Vista with USB 2.0 flash memory drive now. All you need is a high speed 4GB flash memory only to create a bootable Windows Vista on flash memory drive.This is much faster than using a DVD, gigabit ethernet, or possibly even some external USB 2.0 hard drives, due to differences in access speed & transfer rate. So below the step to create a bootable windows vista on flash memory drive

Create a bootable Windows Vista on Flash Memory

1. Format the USB flash memory drive to FAT32 file system

Run CMD.EXE and type the following command. Note: This set of commands assumes that the USB flash drive is addressed as “disk 1?. Double check that by doing a list of the disks (type “list disk”) before cleaning it).

1. diskpart
2. select disk 1
3. clean
4. create partition primary
5. select partition 1
6. active
7. format fs=fat32
8. assign
9. exit

1. Format the USB flash memory drive to FAT32 file system

Run CMD.EXE and type the following command. Note: This set of commands assumes that the USB flash drive is addressed as “disk 1?. Double check that by doing a list of the disks (type “list disk”) before cleaning it).

1. diskpart
2. select disk 1
3. clean
4. create partition primary
5. select partition 1
6. active
7. format fs=fat32
8. assign
9. exit

2. Copy Windows Vista’s DVD ROM content to the Flash Drive

Type in command to start copying all the content from the Windows Vista DVD to your newly formatted high speed flash drive.

* xcopy d:\*.* /s/e/f e:\

this may take some time..

3.Now go to your BIOS and select your USB Drive as 1st Boot Priority.

4. Install Windows Vista from flash memory drive

Source : Techmixer